Discussion Locked

Intel 815E/ATA 100/ Windows 2000 snafu

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a NEW Intel 815EEA board, a New WD 20.5gb/7200 hard drive, new SD133 memory sticks, and a new 80 pin connector cable. I really want to complete an initial Windows 200 Pro installation uisng thsi supposedly "high speed" combination.
However, I keep getting paging errors and cannot find boot drive error messages after initial load on either entire HD NTFS partition or a partial load of 4gb. I have swapped memory out, swapped cables (even going to the 40 pin cable). Strangely enough, I getsimilar issues when trying an initial Win 98 load as well as an NT 4.0 load (after fdisk-ing previous aborts) The HD is OK--it is now sitting on another system. I have gone to the Intel web sight and downloaded the latest board and chip set drivers.Although the site specifically mentioned known problems, there was no immediatley available "initial format/load" discussion/resolution. Essentially,I found zero support but a lot of the same kinds of problems noted in a few discussion threads in W2K. The Microsoft web maze offered upvery little, essentially in same vein.
Where do I go from here?

2 replies

by smurphious

ok... firstly, have you a second HDD physically installed in the PC? what cpu are you running, and have u got a suitably powerful PSU to handle this?
if yes and no applies to those questions respectively, then have you any unusual hardware installed? eg cheap 'no name' components? if so try removing these and any other un-necessary hardware during your install. My sytem refuse outright to install win2k or 98se with an unknown SCSI adapter installed, despite it having been recently been removedfrom a similar spec system.
or, what are you using as the boot device for initialising the install? i would recomend the win2k CD itself.

by scottcox

Thanks for your input. No, all is OK with the hardware. Started first with a P3-700, then fell into diagnostics with a Celeron 533. First step I did was check cables, then started pulling all of the boards because of the W2K blue screen--a left over from NT quick fixing.
I am trying to install from an original CD to a new, single HD. Between each aborted attempt, I went in with DOS and Fdisk'd the drive to make it look empty. Bios was set up with Boot from CD then floppy then HD.

This discussion is closed to new replies.