10 replies
by flemingwp Accepted solution
by willcomp Accepted solution
by flemingwp Accepted solution
by oh smeg Accepted solution
You have to use a PS2 Keyboard till after you install the OS. USB Keyboards require the USB Driver to be loaded and this requires a OS to load the USB Keyboard/Mouse Driver into.
Col
by willcomp Accepted solution
by oh smeg Accepted solution
But with some of these 845 Chip Set M'Boards what should happen and what does actually happen are 2 different things when it comes to USB usability.
Some will only allow you to Boot off a USB Device when you set the USB to Legacy and not use a USB Keyboard/mouse while others will allow you to use a USB Keyboard/Mouse.
Just depends on the version number here of the actual Board in question.
Col
by flemingwp Accepted solution
by oh smeg Accepted solution
You can Flash the BIOS with the newest Firmware available for your M'Board by downloading the BIOS Flash Utility and new BIOS File from the M'Board maker.
Or you can replace the BIOS Chip with one with the latest BIOS by buying one from here I always buy new BIOS Chips for Servers as Down Time is way to expensive for the companies and it's not worth the risk of a BIOS Flash going bad.
However if it is something like an older version M'Board you need to remember that different Revisions can have different circuity involved. This can be done to make better use of existing features of the Chip Set and isn't backward compatible. Basically you have to live with what you have and work within it's limits. A PS2 Keyboard will not cost you more than $9.00 AU and it's not worth messing around trying to make something that doesn't want to work work.
Col
by flemingwp Accepted solution
Hi Col,
Thanks for the advice, the problem even with flashing from floppy or cd is I still need an active keyboard to continue with that process, I have flashed serveral bios chips with an eprom programmer I have.., although I have never unsoldered a bios before, I like a challenge.., the board in question is not a critical component so nothing will be affected by it been out of action at the moment.. I am pretty convinced it is a bios issue though.
by oh smeg Accepted solution
One without an Earthed Tip and preferably Temperature controlled to something like 312C. Solder melts at 310C so a couple of Degrees more but not any more than that will give you enough heat reserves to do the job safely.
Also use Electronics Solder the thin stuff with a High Silver content and you should be OK.
Col
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending