Discussion Locked

internet sharing bwtween winXp and WinMi

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have 2 pc, one with winXp and the other with winMillum. Both have network card.Currently i m using that WinXp Pc to connect to internet using Hurricance800 broadband.SO how can i set up that WinMil PC to connect to internet as well without additional hardware.I just wish to set up internet sharing between them.( i dont have good computer knowledge)

Hardware available
x cable
02 network card
01 hurricance broadband.

thanks if some one can guide me in detail

8 replies

by connectknee

Hi,

What you'll need is a broadband router and a Hub or Switch. Once you get these items then do the following:1)install the router on your hub. 2) Connect the modem to the router. 3) If yor ISP assigns you an IP address dynamically, you set therouter for dynamic addressing. If the ISP assigns you a static IP address, you configure the router with the same address that your ISP assigned to your computer.4) Use the the DHCP service provided with the router to assign an IP address to the winme or do it manually. Now your set to have boyh computers share the internet.

Good Luck,

Paul

by connectknee

Hi,

What you'll need is a broadband router and a Hub or Switch. Once you get these items then do the following:1)install the router on your hub. 2) Connect the modem to the router. 3) If yor ISP assigns you an IP address dynamically, you set therouter for dynamic addressing. If the ISP assigns you a static IP address, you configure the router with the same address that your ISP assigned to your computer.4) Use the the DHCP service provided with the router to assign an IP address to the winme or do it manually. Now your set to have boyh computers share the internet.

Good Luck,

Paul

by c.mcfadden

in you windows XP do a search in the help for ICS(internet connection sharing)it has a step by step to share ur internet.There is no need to get a router or hub as u stated you have a cross over cable and a nic in both pc,If you want security add another nic to the XP box and you have a basic router,Really straight forward and u will have no problem if you follow the steps.

good luck

by c.mcfadden

All you may need to do is release/renew you ip,you should not have to install driver or anything eles after the setup of ICS.Go to the RUNCMDIPCONFIG /RELEASE IPCONFIG /RENEW.This will release/renew ur ip address.

by lemon0309

With the current equipment you have right now, you will have to use the Internet Configuration Wizard to have the XP machine access the option: Internet through this machine and other computers connect to it. Then you use a cat5e cross-over cable to connect the other one. You can make a setup disk using the wizard for the ME machine. Although this works, my sugesstion is to use a router to configure a new network, allowing better connectivity and higher speeds. Routers range from 80 to 200 for Home models.

by vicoery

hi helpful friends out there

Currently i tried to setup on winXp on the network conection,"setup home or office network"
after i finish the step and create a network setup disk. This WinXp PC unable to connect anymore. i need to re-install my broadband driver and internet setting.So how am i going to setup internet sharing connection?
IS there any other setting like TCP/Ip.

This discussion is closed to new replies.