Discussion Locked

ISA Server in Front of EXCHANGE 5.5

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Can't successfully publish my Exchange server. From INSIDE my network I can telnet to 10.1.1.5 port 25 and get a successful connection. From the ISA server I can also telnet to 10.1.1.5 25 successfully. But when I Telnet from outside the ISA server I cannot connect. Is there a log on the ISA server that shows redirected traffic? It seems the Outer Network Card is not sending the request through to the Internal address. Any ideas? I used the 'secure mail server' wizard to create the protocol rules.

3 replies

by curlergirl

It sounds like port 25 on your ISA server is being blocked. Check your packet filtering - you have to open (allow traffic on) port 25 (there is a pre-defined filter, I believe, that you can use). I don't know if the server publishing wizard does this automatically for you - I think I had my packet filters in place before I used it. You also need to add the IDENTD predefined filter. Hope this helps!

by curlergirl

PS - the predefined filter for port 25 I referred to above is identified in ISA Server on the predefined filter list as SMTP. If you're not familiar with packet filters in ISA, go to Access Policy/IP Packet Filtering in the ISA Server console. Youwill see if there are any existing ones set up, make sure they are enabled if appropriate, and can right click and add new ones from there.

by joe barton

It was because I had IIS running with the SMTP service going on it, ISA would not bind to port 25 with that running, I un-installed IIS and it let traffice through...I will give you the points if you can tell me why now that I can connect telnet to port 25 but only get a black screen and now mail server promts.

This discussion is closed to new replies.