Discussion Locked

Joingin to an NT domain

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a NT Server based network and my query relates to connecting NT workstation to this network. I go through the normal motions and join the network through the network neighboorhood, it welcomes me to the domain, then reboot but I get an errormessage that says the computer account does not exists in the domain. I have to log into the local computer, change the setting to join a workgroup and thn try to rejoin the domain. It will then join the domain with no problem. My query is why will the compuet not join the domain on the first occasion but have no problems on the second attempt. This query relates to all NT computer that I try to join to the domain.

Please help.

7 replies

by bill cassada

When you join a domain you have to add the computer account to the PDC (primary domain controller). If you have a BDC (backup domain controller) this is the computer that is actually authenticating your access to the domain. When you add the computer initially it adds you to the system on the PDC. A process takes place several minutes later whereby the PDC updates the BDC. Until this process takes place the BDC, which is the authenticator, does not know to let you have access to the domain. You can resolve this problem by adding the computer account at the PDC and re-sync'ing the domain before adding the workstation to the domain. Hope this helps!

by miracle

To the best of my knowledge NT synchronises information between PDC and BDC`s every five minutes. As mentioned I make the computer re-join a workgroup then rejoin the domain which takes less than 5 minutes. I have been doing this for about 3 months now so I refuse to believe I have managed to accidently get the timing right on every ocasion and join the domain just before it synchronises. However I do believe it could be connected to the fact that I am initially authenticating via the BDC soI thank you for pointing that out.

by susan.krohn-lane

Do you use DHCP services? I found in instances that if you say NO at setup that you do not use DHCP, go in and config the domain name and reference any dns or wins server you may have setup and then activate the DHCP addressing that you will be able to add it on the first try

by miracle

I am not sure if this would work but I do not find this an acceptable solution as we do use DHCP and this appears to be a work around, not a solution to the problem. I thank you for your response anyway.

by ronnonf

There are 2 ways of adding an NT based machine to a NT domain. The first is to add the machine name to the domain via Server Manager then synchronize the PDC and BDC. After this is done then join the domain via Control Panel:Network. I prefer doing it this way.
The other way is to make sure that there are machines names in the server mgr with the same as the NT box you are adding. Then go to the Control Panel:Network (the NT machine) and join the domain. Don't forget to type in the Admin id and password. You will be asked to reboot the machine.
A quick hack is to just start the Netlogon and Wrk services.

by miracle

I have resolved this issue. The problem was as I was ghosting workstations, the6y all had the same SID. Once I change the SID they all joined no problems.

This discussion is closed to new replies.