Discussion Locked

Just loaded up Win. ME

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Everything appeared to go ok. Then, when the windows screen came up a RUNDLL ERROR; %_SYS_MOD_PATH% Tried to hit start, froze start button. Tried to hit my folder, again, folder frose. Tried to reboot, same error. Tried to reinstall ME, same error came up. I seem to be dead in the water past the windows screen. Microsoft was no help either. Do I have a first or are they just being their ----selves?

3 replies

by ebob

Win ME is not without its problems, and given that XP is on the horizon, I would not put money on seeing ME fixed. Ever.

However, this install problem I have not heard of with ME, before. The good news, maybe, is that I've seen something similar when installing 98 and NT4. The problem seemed to be with PnP installation of system "extras", especially NICs. We had a workaround that went like this:
- strip the computer down to its bare minimum (especially remove NIC!)
- FDD, HD, CD-ROM, VGA, KBD, Mouse, RAM
- flash the BIOS on the MB
- then try to install the O/S
This normally went fine. Then create a recovery disk, and so on.

Shut down and physically install the NIC. On reboot, ME will see a PnP NIC and try to install it. For most NICs, you should cancel the PNP installation. Then run the SETUP.EXE from the NIC mfgr. and reboot. At this reboot, let PnP load up the NIC and you should be OK.

by falsedawn

You are mostly right. Although I never was able to find which item loading was the problem, the net result was to pull everything out and fdisk the drive, starting all over again, inserting one at a time. Pain in the ass. Had two computers with this problem, with not the same makeups.
Thanks for getting back to me.

This discussion is closed to new replies.