Discussion Locked

Laptop network problem

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am having serious problems getting my laptop and home desktop to talk to each other. Both machines are running XP. I have allocated the IP addresses 192.168.0.1 & 192.168.0.2 and the subnet masks 255.255.255.0. I have also ensured that they are members on the same workgroup but they still refuse to see each other. I am using a direct cable (cross over RJ45) to link the machines, which has worked OK in the past. I am sorry to ask such a stupid question but it's driving me insane! What other settings should I consider/change - Any advice would be greatly appreciated!

4 replies

by dinatenga

Thank you for the question, I have a short idea.
Try to chack if the drivers for the cards used are installed properly.
That means check if at all there is a network card conflicts.I think you have used the wrong drivers for your cards.

Secondly, test your cable if at all it is punched properly by using cable tester.

by justanadmin

Can you ping one from the other using either IP address or hostname? If not, try pinging the loopback address on each of the pc (ping 127.0.0.1) which will at least tell you if the protocol stack is doing what it is suppposed to. If it fails the loopback ping, you either have a problem with the protocol stack (TCP/IP) or the network card itself (either drivers or bad card).

If the loopback ping works on both systems, but they cannot ping each other, I would suggest trying a different IP range purely as a test. Also, XP has some built in firewall functions that may be preventing them from communicating as well.

The following link gives you some basic info on the built in firewall (remember to remove any spaces):

http://www.duxcw.com/faq/win/xp/firewall.htm

Good luck, hope this helps!

by compserv

Try adding another protocol... NetBios would be a good one to try...... There is nothing to configure for NetBios

If that works uninstall and then reinstall your TCP\IP...... Sometimes TCP/IP gets messed up and you have to start over with it.....

Make sure something is shared from each computer

by skenny

If they can ping but you can't see try to enable the guest account
right click on my computer and go to manage
Local users and groups, choose users
Right click on it and go to properties and if there is a check in account is disabled take it out.

good luck

Skenny

This discussion is closed to new replies.