Question Locked

Laptop shuts down/no BSOD or warnings

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm not sure what to make of this. I have a 4 y/o HP zv5000t laptop that has:

100GB 4200 rpm HDD
2GB RAM (shows as 1.87GB)
Windows XP Pro SP3

I'll be working on something and *poof* laptop shuts off. I know I have to replace the fan on it, but I'm trying to put that off until I can get the funding for it. I've blown out all of the ports, openings, etc that I could find and I use a Targus HeatDefense pad and am looking into buying one of those Portabook stands.

Why is the laptop just shutting down? What can I do? Any help would be appreciated since I need an answer (if possible) by June 15 (start of summer semester for college). Thank you!

3 replies

by rob miners

I would give the inside of the case a blowout with compressed air. When blowing air through the fans make sure that you physically stop them from spinning, as they may generate power and cause damage.

Next, remove the Heatsink, give it a thorough clean with a cotton cloth and reseat the CPU applying new CPU grease. Arctic is a good brand.

If the Fans spin freely when you give them a spin they are probably OK. If there is resistance replace them.

Clean the Cooling Vents

Depending on the model, vents can be found on the side, back, and/or bottom of the notebook PC. These vents allow air to flow through the PC and keep it cool. Buildup inside these vents impedes the cooling process.

Clean I/O Ports

The back of the notebook PC has a series of ports. After cleaning the cooling vents, take the compressed air and blow out any debris that may have accumulated in and around these ports.

Clean the RAM

Clean the golden edge of each memory stick with a soft rubber/eraser, remembering not to touch the golden edge of the memory stick. Check with one stick at a time, remembering to disconnect the power from the PC.

by oh smeg

This is the only means to provide cooling to the CPU and when this overheats which it will without a constant stream of cool air passing over it's Heatsink the Circuity of the M'Board shuts it down to prevent damage.

While the Cool Pad that you are using is sufficient for some NB's it's not really the best option you should use a Cool Pad like the one supplied by Antec listed here

http://www.antec.com/Believe_it/product.php?id=NzI=

This creates a high speed air stream under any NB and sucks most of the bigger bits of Airborne dust and other crud away from the air intakes of the NB thus preventing any of it entering the NB and blocking the Fins on the CPU's Heatsink.

Col

This discussion is closed to new replies.