Question Locked

Laptop won't boot, can't access et setup

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My laptop frozes after I reboot,I'm not able to load the OS (XP Pro).Safe mode LGNKC etheir,
Try to rinstall the Os but,can't even access setup to change the boot sequence.
Can somebody help?

7 replies

by mjd420nova

Too many of the newer virus/hijack worms out there today are of the type that will reflash the BIOS. The only cure is to remove the battery for the CMOS and let the unit go into the default BIOS. Then you should be able to get back into the BIOS and make the changes you need and restore the settings to suit the hardware installed. Good luck

by kiltie

What computer do you have?
Any idea what the mobo is?
What is LGNKC? North Korea Nuclear Challenge?

by itp15_aimedjetouand

That should have been spelled Last Known Good Configuration (LKGC).
I have an ASI CL51-15 notebook.
I was trying to follow the previous instruction but the computer is difficult to disassemble.I took off all the screws but can only half open the lid!

by vadivel.murughan

Re installing OS could be a solution, as only this not only formats ur laptop also gets rid of unwanted virus...

by older mycroft

If you had read the actual problem you'd realise the poor bloke couldn't load the OS because the boot-sequence was HD first!!

Honestly, try reading the whole post next time. :)

by Former member

More memory up it to 2gb (if possible).
Put in the new drive and memory and see if you can then get into your bios.

Please post back if you have any more problems or questions.

This discussion is closed to new replies.