Discussion Locked

Matrox video card failure in NT/2000

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Using relatively new Matrox G450 dual video cards, in a both HP and IBM P3' and P4's. Found there are inconsistencies between these cards which appear exactly the same (ie. G45FMDVP32DB). Build the PC's from scratch, and when do any changes to video settings, eg. adjust from 16 bit to 24 bit. Or just swapping with a different monitor/flat screen can destroy the video altogether. As you move the mouse, it kind of drags the screen with it, different colors, etc. Re-installing SP3, the video drivers (latest or slightly older) doesn't help. I heard of a tweak, but was wondering if anyone had a fix for this OUT THERE! Before I have to call Matrox and go through all the motions with their tech support.
Using w2K, sp3, all MS updates, PC Anywhere, MS Office, McAfee a/v and 5 trading softwares. Had a suspicion it might be a conflict with PC Any, but not sure.
Any tips or if anyone has seen this before would save me a lot of trouble. Thx in advance...

7 replies

by parvus1202

Before you call Matrox, try to get a quality monitor cable, the one that is shielded, see if it works, if not, call Matrox.

by jamie schnabel

I have had this problem several times. If you uninstall pcanywhere everything will be fine. The fix that I have found that works is once everything is installed then reinstall the video card driver from the cd that came with the video card. Try not to use the mouse just the keyboard while doing this.

by skloo77

found this on hp's website since u mentioned HP.

video on the primary display may be corrupted (unreadable) after changing the display resolution of Matrox G400 and G450 dual head graphics adapters in a Microsoft Windows XP (Pro or Home).

initially detects the adapters and installs the drivers it prompts the user to change the display resolution to 800 x 600. If the user clicks OK to accept the change, the issue will occur if the user subsequently changes the display resolution again. However, if the user does not accept the change when prompted, the display resolution defaults to 640 x 480 and the user can then change to any available display resolution without issue.

The issue can occur after upgrading to Windows XP and it can happen if a user installs one of the controllers in a computer that is already running Windows XP.

SCOPE
The issue is not specific to Compaq products. It can occur on any computer operating in a Microsoft Windows XP (Professional or Home Edition) environment and having a Matrox G400 or G450 dual head graphics adapter installed.

RESOLUTION
Users can avoid the issue by clicking No when prompted to change the display resolution during the initial hardware detection. However, if the issue has already occurred, users can resolve the problem by performing the following procedure to designate port 1 as the primary display port.

Power the computer off.

Move the primary display video cable to monitor port 2 on the graphics controller.

Power the computer on.

After the computer boots into the operating system, right-click the desktop and select Properties.

Click display 1 to select it.

Check the Extend my Windows desktop onto this monitor box.

Check the Use this device as the primary monitor box. Click OK to apply the change.
Move the primary display video cable back to port 1 on the graphics controller.

by dcoyle

Thx for very detailed answer. I found a tweak on Matrox site which seems to have helped so far. Thx again!

This discussion is closed to new replies.