Discussion Locked

Modem Issue

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Installed new Lucent V.92 modem. Dial up appeared to work properly. Upon next attempt to dial up, error message appeared. It stated that modem was not physically installed or the line was not connected. Upon checking modem diagnostics, communications could not be made with modem, and "port already open" was replied. Upon removing device via device manager and refreshing. Windows found modem, installed software, then dial up worked properly. Then upon disconnecting and attempting to reconnect some time after, same problem again, with the same results.

9 replies

by dmiles

You may need to check with your ISP to see if they support V.92 modem connections,also check the modem manufacturers web site to see if the modem UART settings should be set differently for the V.92

You did not mention what OS or motherboard you have which may have a compatibility issue,this may be why when you reboot the modem is not being recognized.

by paccom

We sell computer hardware and what you are experiencing is just all too familiar. You have got a faulty internal PCI modem card. It has got nothing to do with your driver and/or OS. Just bring it back to where you buy it from and exchange for another one. If you could, it upgrade to a branded one.

by jose_12650

Try unstalling the modem and remove the program that goes with it. Power down. Physically remove the modem. Power back on. Install the program. Power down. Physically install the modem. Power up again.

by choppit

Try using a generic 56Kbps modem driver. I had a similar experience some time ago with a Zoom V92 external(lucent) modem on W2K and tried a number of driver versions.In the end I used generic drivers and all has been fine since.

This discussion is closed to new replies.