Discussion Locked

move from 56kb to Broadband for internet

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am currently trying to make sense of how to change our current modem router connection to the internet from 56k to broadband. Installing the new router is easy stuff and hooking it up to the server via the switch is also straight forward. The problem lies when I try to assign an IP address to the new adsl modem router and give it 2 new DNS server addresses provided to me by our ISP. When I hook up the new adsl modem router all the test signals are fine it is just to get internet working on the server is a problem hence also internet on all workstation is a problem. The server has a second network card for Internet and this internet network card has it's own ip addresses and dns addresses. The question is how do I get to talk to the new modem router once connected and give it our ISP's specified ip and dns server addresses and whether or not I have to change ip and dns addresses on the current internet network card???

Hope to hear from you soon,
Jag.

5 replies

by bobby gillette

If your ISP tests the connection to your router and you're fine, you simply need to set your internal router's default gateway to your adsl modem's internal interface IP. That will enable any connections that have your internal router set as their default gateway (ie your server and workstations) to be able to access the Internet.

I'll need to know how your workstations get their IPs, whether or not you want them to connect to the Internet via your server, etc...

by cat_crap

The previous answer is correct. You don't even need the second nic unless you've got it configured for load balancing. Your PDC just needs to have the vital information to hand down to the clients upon authentication. If your server hands out DHCP make sure that your DNS is inputed and the Gateway address (address of router) so that the clients know where to be directed out for internet access. You might need to reset the ipconfig on the clients once this is done to make sure it works. I've found that so long as I know the information for the network settings it's easier to test on a workstation via static config than to mess with the server and create downtime. Just a thought. Hope this helps.

This discussion is closed to new replies.