Discussion Locked

MS-DOS Problem

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My client has a computer running Windows 98SE, and it boots up in MS-DOS mode. It asks me do I want to go to Windows press Y. When I select Y it always re-booted to MS-DOS mode. It never boot to Windows. What I need to do to get rid of such condition (MS-DOS mode)?

9 replies

by thechas

I usually re-install W98 for this kind of situation.

I suspect that 1 or more key Windows files are missing or corrupt.

The only real problem from re-installing is that you may need to re-install the application programs if the registry is part of the corrupt files.

I would also run scandisk in thorough mode to verify that the HDD is not close to failure.

Chas

by computer_excel

Re-installed Windows 98nd Edition did not help solve the problem. I found in config.sys file there was a line "DOS=Single". When I deleted this line from Config.sys file it fixes the problem.

by computer_excel

I found in config.sys file there was a line "DOS=Single". When I deleted this line from Config.sys file it fixes the problem.

by fenaikh

Hi

1. Make sure that the keys Ctrl and F8 are not sticky which makes it always boot to DOS.
2. Reboot and either press Ctrl or F8 key to go to the boot menu screen, then choose Normal or option 1. This hopfully will boot to windows.
start->serach->file or folder> (type) MSDOS.SYS -> right click on that file which is in the root directory of your boot disk say c:\MSDOS.SYS -> from the list menu choose "Properties"
-> click "Change" in the "General TAB" then choose Notepad from the open with list. -> click "OK". -> when you return to the "Properties" unckeck the read only "Attribute" -> click "Apply" then "OK" go back to the "Search Result", then double click the c:\MSDOS.SYS file . under [Options] section change BootMulti=0 to "1" and BootGUI=0 to "1". Save it then exit.

Go back to the search result then right click on c:\MSDOS.SYS from the list menu choose "Properties". -> mark ckeck the read only "Attribute" -> click "Apply" then "OK", then reboot.

Good luck

Mohamed

by computer_excel

I found in config.sys file there was a line "DOS=Single". When I deleted this line from Config.sys file it fixes the problem.

by jackofalltech

Win98 doesn't ask to "go to Windows" no matter how badly MSDOS.SYS or other files are messed up. This sounds more like a hold-over from a Win3.1 custom config.
Look at the AUTOEXEC.BAT file and see if there is a line with either ASK or CHOICE. If possible, post it here so I can give you better advice.

Ralph

by computer_excel

I found in config.sys file there was a line "DOS=Single". When I deleted this line from Config.sys file it fixes the problem.

This discussion is closed to new replies.