Discussion Locked

Multiple network cards problem

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,
I have a Windows 2000 Server with three network cards. Two is Builtin (100 MB) LAN card and one (1 GB) LAN card. When the server tries to access the other network member that response is very slow. Some time server was not access on the network.
When I restart the system everything works fine.
How can I get this to work?

Thanks.

2 replies

by bchesmer

1st a few questions;

Do you need all 3 NIC's?

If not, do you need 2 NIC's?

If not, disable the un-needed cards via the systems BIOS (You had said 2 were built in, I am assuming built into the motherboard of your server). But before you disable them in the BIOS, remove them from Win2K via device manager, then shutdown the system & boot into the BIOS and remove them there also.

by an_it_guy

Assuming you need all the three adapters, i beleive they all might be on different subnets.
You can start with the basic Ping utility on DOS console, ping and drill-down the network adapter creating problem.
Second & most imp. thing u can check is to get into each adapter properties, and find the settings of adapters. Find something called as "Link speed". Make sure it is set to 'Auto' and not to any specific speed. This is to ensure that it will depend on the speed that client can communicate with the server & not what Server can deliver at.
Hope this resolves ur issue.

This discussion is closed to new replies.