Question Locked

MY HCL-EZEEBEE DESKTOP NOT BOOTING!!!!?????

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello sir,
I am using HCL-EZEEBEE DESKTOP (Purchased in DEC 2006).My system is not booting.It is showing that

"Windows couldn't start because the following file is missing or corrupt.
system32DRIVERSpci.sys
You can attempt to repair this file by starting windows setup using the original setup CD-ROM.
Select 'r' at the first screen to start repair.''
I put the win-xp installation(bootable) CD and tried.After POST,it is showing Press any key to boot from CD.And after pressing a key,in the next screen it is showing "setup is inspecting your computer hardware config."
In the next screen windows setup starting & hangs-up(I waited for maximum of 8-10minutes & noticed no progress).I am unable to solve this problem.Is the HARD DISK is crashed/damaged?Through setup menu I noticed hard disk as SATA HDD.How do I solve this problem on my own(if u suggest/guide)?In case of HDD failure,does my HARD DISK is having 3 Years warranty & be replaced? Please help me soon, all my works are pending.Please,please help me.If I had to contact HCL service centre at HYDERABAD,how do I find phone numbers/address.
-Vijaya Bhaskar

5 replies

by cholan41

Ur in Andrapradesh u don't know HCl DEALER NETWORK /u don't Know HCL WEB ID / r know godavari river ? put it tht

by csvb_siit

I pity U.I hope that u will never repeat the mistake of putting ur DESKTOP in Godavari & openely share it & suggest the same to others on Q&A Forums like this.

by cholan41

Vijaya Bhaskar ur Question like tht i so said like tht Ok
1. boot with bootable cd come dos prompt and reach c:\windows\system32\drivers\
2.If u copy tht same PCI.sys file from other system runing in Xp paste in above said root dic it help to runng the system
3. some time this comes for memory stick try to remove tht and clean well then u reboot .and chk the sata cable also . then only the sytem hang if u boot /repair the said O/s
4.it is not HDD problem. ok

by oh smeg

I got a NB today with the exact same error and the HDD in is is shot so you should check this out by downloading the HDD makers testing utility and Testing the Drive before doing anything else.

If the time taken to reach the error message is appreciably longer than it would normally be the most likely thing is that the HDD is dead. Not a 100% answer there but a good guide none the less.

Now back to the SATA issue, XP doesn't natively support SATA drives so at the very first blue screen you need to push the [b]F6 Key[/b] and wait till you are requested to place a floppy with the SCSI Drivers in the A Drive. At that point you need to insert a Floppy with the SATA Driver for your M'Board copied to the root of the Floppy. You can then load the SATA drives and wait for the Windows setup to reach the option of Installing or Repairing the existing OS. However from past experience I've found that a In Place Install is better than repairing the existing Install so you may consider following these directions

http://support.microsoft.com/kb/315341

If you wish you can make a Slipstreamed Copy of the XP install Disc with the SATA drivers included by following the directions here

http://tinyurl.com/2ehzk3

While addressing the adding of SP2 to the Original XP Install Disc you can also add the SATA Drivers for your Computer.

Post back if you need any more information.

Col

This discussion is closed to new replies.