Discussion Locked

My NT 4.0 "R"epair during setup Horror

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I used the "R" repair selection during setup to repair some NT problems. The problem is that now it doesn't reconized my Administrator password or any other log-ins. I used my ERD disk and it didn't work. I used LAST KNOWN GOOD...nothing changed. I tried VGA mode...nothing.
What do I do now?

2 replies

by shiny_topadm

I would suggest you post the question under TechQ&A, NetAdminRepublic. There's a section on NT that will probably be viewed by someone who can answer this...

This discussion is closed to new replies.