Question Locked

my pc wont work please read

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have a compaq computer 5000 series and my dad has an identicle compaq pc. he upgraded his computer to windows xp from windows ME. so i wanted to upgrade my windows ME to xp too. when i put the cd in it reads it and everything but after it copys all of the files then it restarts, thats when everything goes wrong. it gets to the black screen with the blinking line in the top left corner and the pc compleatly freezes but the line still blinks. and it will run windows 95 fine. i am 15 but i know alot about computers and i am going to school for computers. the computer is a compaq presario 5000 series with a 700mhz AMD duron processer and 312mb RAM and a 6 or 64mb vidoi card. the vidio card came with the pc but there is no vidio card on the mobo. my dad has a compaq presario 5000 series with 700mhz ADM duron processer and 64mb RAM and ether 6 or 64mb vidio card.....................................
what do you think the problem is??? please help me i want my pc to work again...
..........................................
i have another computer that i cleaned out all the fans and stuff now when i turn it on the screen doesnt display anything and i have another 1 that takes a sata hd but it says ntfsl{or something like that} file is missing. Can any1 please help me

7 replies

by oh smeg

Most likely some incompatible Hardware look at the CD Drive or Burner as these where a problem with XP & again when SP2 was released for XP.

You also need more RAM as the amount that you have is really on the Low Side and the CPU is a bit small. While with compatible Hardware this may run XP it's going to be really slow.

[i]i have another computer that i cleaned out all the fans and stuff now when i turn it on the screen doesn't display anything [/i]

Either something is not connected properly and has either become unplugged or Popped off the M'Board I'm taking it that this has been checked or the M'Board or depending on the way used to clean out the system you have given it a [b]Major Static Hit[/b] and fried all the CMOS circuitry. Not Sure which is involved as its very hard to say without actually seeing the affected computer.

[i]i have another 1 that takes a sata hd but it says ntfsl{or something like that} file is missing[/i]

Without knowing the exact error message it's impossible to say but a reinstall of Windows should put the situation right though you may need access to a Floppy to install the SATA Drivers for XP. You need to get a copy of the SATA Drivers and copy them to the Root of a Floppy and then when the first blue screen appears after starting off the CD you need to press the [b]F6 Key[/b] and load the SATA Drivers.

Col

by tintoman

If you are trying to upgrade your operating system by inserting the XP disc while windows ME is running I would suggest that you boot your machine from the XP disc, then you might find it will work better, also it would be better if you chose a clean installation of XP rather than an upgrade.
computer 2 I agree with Smeg, you have probable dislodged the graphics card or even the processor when you cleaned it.
computer 3 you will not be able to install any version of windows prior to Vista unless you install drivers for the SATA hard drive during the installation by pressing the F6 key and inserting the floppy disc - again I agree with Smeg give him the thumbs up I say

by smiththewrestler

ty both^_^... in my dads compaq he has 64mb ram and i have 312 his is slow but it works...............................
pc2 the processer i took out and fixed a different computer with because i couldnt get it running.i think i fried it ........and.........
pc3 ty i will try..........................
pc3 is the better of the 3 better processer and all...................
pc3 was given to me cuz it shut down by its slef and when it was started back up the >>>>>file missing error came up...........
tytytyty both very much.................
what do u think the chances of getting pc3 running?????????????
what do u think the chances of getting pc2 running??????? i am at school but because of the weather we are being let out early:)
tytyty vm

pc1: compaq presario 5000
pc2: alienware custome pc
pc3: cysnet

by ic-it

Boot from the XP CD and choose the first R for Recovery Console Repair.
Once in Type Chkdsk /R
If it finds and fixes errors, run it again until no more errors are reported.
If this fails and XP is on that computer, then try Fixboot.

by smiththewrestler

thank you all for helping me failed to get pc1&2 to run xp but i formatted hdd in pc3 reinstalled it and now i am typing this up on it ^_^ i cant thank you all enough. at first i thought noone was going to answer because there were other people posting after me and theres were answered but you guys/girls came through

by thumbsup2

We all have our special "niches" where we sort of look for questions that we know we can answer. Sometimes, the best person to answer your question hasn't come online yet. So, questions that get posted after yours might get answered before yours.

Eventually, I think we find them all. But, if your post drops off the radar screen (off of the visible list of posts), just find your original post from your personal list and reply to yourself with "bump" in the subject. That brings it back into view again so we can all see it and hopefully the people with the expertise in that field will be online at that time to help you.

This discussion is closed to new replies.