Question Locked

My signal from my grx card to moniter*PROBLEM*

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I was talking on msn and all of a sudden my computer when that ugly microsoft XP blue (totally blue) I have been running on 75hz(refresh rate) and currently running on NO grx card (I disabled the integrated card) I even went into the bios and selected the device to PCI-E.It's not recognizing the video card is pretty much what I'm saying, was working yesterday, tried uninstalling the 6150le and then unplugging it turn off the computer then plugging into the DVI. Still does not work!
So any help would be WELCOMED!

4 replies

by oh smeg

But none the less 75 Hertz is fairly fast for most monitors. You normally run at 60 Hertz for most monitors except the high end Digital ones so it just may be that the Monitor can not read the signal from the Video Card.

When you start the computer do you see a POST Screen? I'm assuming that you do because you have said that you can change the BIOS Settings so I would be looking at a Problem directly in Windows.

At what stage do you loose the display?

Also have you tried another monitor on this computer to see if that cures the problem?

Col

by cssninjasadmin

*SyncMaster 712N/711N*

Currently Running on integrated chip of.....Geforce 6150 LE *REV 2*.... current refresh rate of...... 60 mhz on ... 6150 LE

Lost signal when I got up and I tugged onto the USB cord of my microsoft headset VERY LIGHTLY!

I have tried a nother moniter a MAGNOVOX hd t (not sur eof model number) and it said "No video signal". When I plug it into the dvi slot on my card and hit the test button onto my moniter (the samsung one *712N* it says "test is good". So I am wondering what si the problem.....

by oh smeg

If you are not seeing any thing at all on the monitor from the computer at least that would be where I started looking replace the Power Supply and after removing any unnecessary external devices and try again.

Actually you should remove everything unnecessary to the booting of the sys ten and see if things improve from there. If they don't replace the Power Supply. Even if the fans run replace the Power Supply I've seen cases where a customer has replaced a M'Board, CPU and Video Card with no improvement and then brought it to me for repairs expecting that the RAM also needed replacing and when I plug in a Known Good PS the system works perfectly. I've tested the components pulled out of the system and replaced and they all work as well so it was a very expensive attempted repair that didn't do any good. They didn't even save themselves my fees as they didn't consider that the PS was the problem.

If you pulled the Headphone lead it's also possible that this time you broke it as it wouldn't be the first time that this has happened so unplug this before proceeding any further. If the internal leads have shorted out it may have damaged or destroyed the M'Board.

As for the Monitor passing the test this is only telling you that the monitor is connected to a Video Source not that it is actually working. The Test function sends a plus down the Video Lead and if it gets a reflected signal it knows that the monitor is actually connected to a Video Card of some description. It however doesn't mean that the video is actually producing any signal or even working. If you perform this test with the computer turned off and the mains plug disconnected you will get the same result.

Col

This discussion is closed to new replies.