4 replies
by thechas
Hi Wayne,
The peripherals from the VPR should not give you any problems.
The likely reason that the HP restore disk does not work is that you upgraded the operating system.
Did you switch the file system to NTFS?
Or, perform a clean install of XP?
Either could cause the HP restore program to not recognize the system.
Also, HPs agreement with the software vendors my limit the restore CD to use with the original configuration.
All files on a CD are read only.
This simply means that you cannot write to them.
You might be able to browse to the individual programs on the CD and run the install or setup program from there.
As to your freeze problem, I'm at a loss at the moment.
What speed is the CPU?
How much RAM?
How much free hard drive space?
XP likes lots of RAM, so unless you suspect that you may have bad memory, I would not remove any RAM.
Be aware that the amount of installed RAM is 1 of the product activation items. So, don't change the amount of installed RAM if you can avoid it.
However, if the RAM modules are different brands or types, you can have problems with some systems.
This does not happen a lot, but I try to keep all DIMMs the same in my systems.
How about Windows Updates?
Chas
by thechas
Another thought,
Clear out the recent files and temp folders for each profile on the system.
Chas
Chas I am running on a celeron 850Mhz......... Installed memory,128 MB. I added 256 for a total of 384 MB. HD space is fine. I have 10GB avail. I checked windows updates and I have already downloaded all the available ones. The RAM I purchased from Crucial was compatable when I purchased it. So I guess the memory is okay. As far as the clean install, yes I did do a clean install. When I installed XP from the upgrade disk, I thought I had to choose the NTFS file sysytem because that is the file system for XP. How can I check to see which file system was originally installed? Or, am I beating a dead dog here.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending