Discussion Locked

NetBEUI in a mixed WIN 9.x enviroment

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a nine workstation office that is using NetBEUI for connection between machines. The environment is mixed between 1 WIN NT machine and 6 WIN 95 and two WIN 98. The problem I have is, I replaced one of the older WIN 95 machines with a WIN 98. Once I set it up and added the NetBEUI protocol, it was not able to see the other computers on the network and vice versa. I tried everything added all other protocols along with NetBEUI. Still nothing. I finally installed win 95 and added the NetNEUI and it worked the first time out. Since I have WIN 98 machines running NetBUI already in the environment why wasn't I able to add another?

11 replies

by brianaaa12

Try installing File and Printer sharing, if it's not already installed. I don't know how long you waited, but in windows 98 it can take up to 15 minutes for other computers to show up in Network Neighborhood. Did you try using Start|Find|computer? If you try this and can find a computer, it may just be a matter of waiting for browse service to update.
Check TechNet document Q192534. It has some extensive steps in troubleshooting Win98 networking problems.

Brian

by flowcom

That was it. I am sorry about taking so long to get it solved. But I had expected my new 98 machines to arrive within a few weeks after I worte this. But because of a bad mistake on the ???? (Major computer Name withheld) I finally got my 16actually they still messed up and sent me 14 machine last week. Thanks a bunch.

by craig it mangaer

From my experience, it could have been either the time issue, which can take awhile before it "sees and can be seen" or a bad install. The bad install is probably the most likely and even if you remove the protocol the files still remain in windows and will not be properly over written. You either have to wipe out the install as you did or manually search for the files loaded when installing netbeui and remove them and then try to load the protocol again.

by flowcom

That was it. I am sorry about taking so long to get it solved. But I had expected my new 98 machines to arrive within a few weeks after I worte this. But because of a bad mistake on the ???? (Major computer Name withheld) I finally got my 16actually they still messed up and sent me 14 machine last week. Thanks a bunch.

by lyf

Hi Flowcom :)
In addition to the above answers:
One of the common problems with mixed Win95/98/NT networks is the election of the
"Browse Master" under File & Printer Sharing Services. In this case, you should manually elect which machine(s) are to serve as Browse Master and backups (Usually WinNT or 98 machines).
Right click on Network Neighbourhood, and then select Properties for File & Printer Sharing on each client. For the Win95 machines, choose "Disabled" in the drop down box for "Browse Master" rather than "Enabled" or "Automatic". Choose "Enabled" for the WinNT/98 machines. Of course do "OK's" as required and reboot each machine.
This should help resolve the problem until your machines are all at the Win98 level
or above, when you can revert to "Automatic" for all.
Hope this helps,
Ron

by flowcom

That was it. I am sorry about taking so long to get it solved. But I had expected my new 98 machines to arrive within a few weeks after I worte this. But because of a bad mistake on the ???? (Major computer Name withheld) I finally got my 16actually they still messed up and sent me 14 machine last week. Thanks a bunch.

This discussion is closed to new replies.