Discussion Locked

Network problem

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Sorted the problem our

4 replies

by rob111972

Dear Friend

Your problem is either the Hub you are using is not good or check the cabling

Engr. Robinson
+2348023254076

by gregross

What is the speed and duplex setting on the nics for the computers that don't work? It is likely that you need to configure the ones that don't work to operate at 10 half duplex or 100 half duplex.

by emollo

Greg, how do you change the speed or duplex for that matter. When I change it to the 8 hub port it works very well and shows connected at 10.0. But when I put it on the other, the speed is 100. and doesnt work. Show me how to chang the speed. Thanks for your effort to help me

by deepsand

This is a tech. problem, in search of a solution.

It properly belongs in "Technical Q&A," not in "Discussions." There you will be more likely to get the attention of those seeking questions that they might answer.

You should re-post there.

Thank you.

This discussion is closed to new replies.