Discussion Locked

Networking

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

While setting up a small LAN I found I had a pc (win 98) that couldn't find the LAN server via a login. However, I could ping the server from that pc. I checked for the usual mistakes: NIC seemed ok in Device Manager and light was on, cat 5 outlettested ok, patch cord tested ok.

I also noticed that I had misspelled the domain name in the Login box, but after correcting still no network. After being told the domain couldn't be found, I clicked "OK" but quickly found the server in "Network Neighborhod".

Any Ideas?

9 replies

by sindian

are you in the right workgroup??? If you can see it through network neighborhood have you tried mapping a drive and see if it connects check the server if you can't map is the share name right??

by mckaytech

Since you can ping the server, I'm assuming your IP address/subnet/gateway entries are okay and since you can see the server in Network Neighborhood, it sounds like browsing is working.

So... have you checked the "log on to domain" box? If yes, have you done an ipconfig /release ipconfig /renew cycle to update the WINS server?

paul

by calle lindström

Look in to client for microsoft networks,
if there is a nt-domain where to log on,
you can try to rename worgroup at the same name in identification box.

by spydergst1

If you can ping the server then there is no need to check the cabling. Try removing client for microsoft networks reboot then reinstall it. If this doesn't work then, check your wins and dns configuration. Configure the DNS search order. Hope this helps.

by bbennett

This must have done the trick. I did everything I knew; including changing nics. I removed the "Clent for MS networks", rebooted, reinstalled and rebooted again. Finally, I was able to login and see the network. Now I wonder why this happened?Sincere thanks!
Belinda

This discussion is closed to new replies.