Discussion Locked

Networking Solaris 8 to W2K network

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have solaris 8 installed on an intel based computer. Everything is working fine, except I can not get it to connect to the network. The cable is pluged in and during the isntallation, I put in a valid ip address. I would like a step by step guide on how to connect the solaris to a network to browse the web and share files. Any help is appriciated.. Thanks in advance.

5 replies

by hurrikane

If you are sure your network card is at least loaded by the OS then you can try these options. I have found most of the time it's just a configuration issue.

1. Make sure you have the following files.
/etc/resolv.conf = DNS and Domain
/etc/defaultrouter = Your gateway

The /etc/resolv.conf should look something like this;

search yourdomain.com
domain yourdomain.com
nameserver
nameserver

The /etc/defaultrouter should just contain the ip address of your gateway, typically a xx.xx.xx.254 address.

Also check to make sure your /etc/netmasks file is set correctly. If your ip address is something like 10.31.11.2 and assuming your netmask is 255.255.255.0 then the file should look like 10.0.0.0 255.255.255.0. when you look at the file this will make more sense.

You can also just reconfigure your network card with the ip information again. Since your using the X86 version of Solaris your network card device should be reference by an elx0 (zero).

Try this;

#ifconfig elx0 down (enter)
#ifconfig inet netmask broadcast (enter)
#ifconfig elx0 up

To verify the settings type this;
#ifconfig -a

This will display your loopback and the elx0 device which will be your NIC. You should see the inet address which is your IP, the subnet mask which will show in hex as ffffff00 and the broadcast address which should be your ip address except the last octet will be .255

255 is the broadcast address. If none if this helps then you may need to run the interactive setup and try to get the OS to recognize your NIC again. Or 'unplumb' then 're-plumb' the card. But that's where my knowledge ends.

If you want to share files with Windows based pc's then you need to look at a package called Samba. It allows you to setup shares that Windows clients can see and access.

- Mat

by ghislain.levesque

After you have try all info in answer #1, verify these :
- is there any light on the adapter on your server
- any light on the switch or hub your plug-in
- have you test your cable, take one who is working on a different pc or any equipment that working.
- if your plug-in the wall, try a different plug, or even better direct in the switch/hub
- can you ping other ip address
- try changing your adapter in your pc

and last resort, run sy-unconfig and reboot, this will prompt you after the reboot, hostname, ip address, network card to use etc...

Good luck

This discussion is closed to new replies.