Question Locked

New Hardware when there is no new hardware

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Windows XP Pro x64

Suddenly i am confronted on startup with a dialog box stating that new hardware has been found, yet doesn't state what new hardware.

Then it goes through the cycle asking for companion CD and eventually can't find driver.

I haven't installed any new hardware, the above just started one day on boot-up and can find no way to eliminate this annoying problem.

I have seen this mentioned once before, but can find no effective cure. I would be grateful for any advice given

4 replies

by tig2

Run a registry cleaner such as CCleaner. Make sure you save a backup of the registry- CCleaner will prompt you to do so.

My experience is that some software can trigger the "new hardware" search. It is possible that this is the situation that you have.

Please run CCleaner- assuming that you try this tool- recursively. It will find new things on each pass. If you save the backup on the first pass, you do not need to save subsequent backups. You can download CCleaner at http://www.ccleaner.com.

Good luck!

by haggis33

Hi TiggerTwo;

Been there Done that. I am an advocate for running CCleaner after every session I have on my computer, be it three or four times in a day. I like to clear all unwanted items from my computer and so far after thirty plus years I've never had a virus attack.

Thank you for your quick reply I appreciate it, but unfortunately doesn't help me.

Charmars

by Former member

While CC cleaner, which Tigger suggests, is a good product for what it is, different reg cleaners do different things. For this type of problem I use System Suite 6.0. I think the utility only version is Fix-it Utilities.

System Suite is much slower than many other reg cleaners, but it is also much more thorough and dangerous as well. However, there is a very good restore function if you are to aggressive.

The diff is free vs. commercial.

Any thing after version 6 is junk, so if you have a choice and prefer this method, insist on version 6, not version 6.3.x, 6.1.x is also decent. Version 6.3.x & up has call home software which reports what function you are using and what you are deleting. When calling home it uses UDP ports 1039 and 1035.

This discussion is closed to new replies.