Discussion Locked

no signal input

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

After I have been away from my computer for a while, the monitor blacks ou as it should, but some times when I come back to it, a movement of the mouse will turn the monitor back on. However, I have been receiving a message "no siganl input, or cable disconnected or lose". If I turn the monitor on, I get the colored lines and have to use my reset button. This is not a problem unless I am downloading something, and then I lose everything that has been downloaded to that point.
How do I correct this, so that when I move my mouse the monitor turns on and the Desktop appears, or the downlaod appears.
Thanks

9 replies

by c.mcfadden

try going into the control panel>power option>and set the home/office and change the setting to NEVER turn off monitor.

by sbhuck

I tried the things mentioned in to first two answers, but noone of them worked. Still looking for an answer.

by sbhuck

I ask Microsoft about this, and they told me use the Power Management Troubleshooter. When I did this, the problems showing up were:
1. 0317 DEVNODE NETWORK\FAMILY\0000
0137 Device Microsoft Family Logon
2. 0143 DEVNODE NETWORK\MSTCP\0000
0143 dEVICE TCP/IP
3. 0151 DEVNODE ROOT\NET\0000
0151 DEVICE DIAL-UP ADAPTER
4. 0157 DEVNODE NETWORK\FAMILY\0000
0157 DEVICE MICROSOFT FAMILY LOGON
5. 0163 DEVNODE NETWORK\MSTCP\0000
0163 DEVICE TCP/IP
6. 0171 DEVNODE ROOT\NET\0000
0171 DEVICE DIAL-UP ADAPTER
7. 0187 DEVNODE NETWORK\FAMILY\0000
0187 DEVICE MICROSOFT FAMILY LOGON
8. 0193 DEVNODE NETWORK\MSTCP\0000
0193 DEVICE TCP/IP
9. 0201 DEVNODE ROOT\NET\0000
0201 DEVICE DIAL-UP ADAPTER
10. 1857 DEVNODE ROOT\NET\0000
1857 DEVICE DIAL-UP ADAPTER
11. 1867 DEVNODE NETWORK\MSTCP\0000
1867 DEVICE TCP/IP
12. 1875 DEVNODE NETWORK\FAMILY\0000
1875 DEVICE MICROSOFT FAMILY LOGON
Just started to research this, but not being overly computer literate, I could use all the help I need. Thanks.

by mmccaskill69

Go into power options and set the HDD power save setting to "never" and set the monitor to whatever specified time you want the monitor to go into power save. Next, see if your monitor has a power save mode option in its configurations (Should be able to see the configurations by manipulating the buttons on the monitors face). Turn the power save function off if the option is available. This has worked with systems I have come across with the same issue. You also may want to check your power save functions in the BIOS if your MOBO is equiped with power save options.

This discussion is closed to new replies.