Discussion Locked

Not all of installed RAM is seen by NT

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This is an older system, DECpc XL560 (60Mhz P2).
I am trying to give it a little life by max'ing out the memory. I have installed 6x32MB in the available 72 pin SIMM slots which is the max configuration supported. The RAM modules are FPM, 70ns, parity with (I think) a 2K refresh rate.

When booting up the BIOS sees all 192MB of installed RAM. Windows NT SP6a sees only 65MB. If I install 64MB or less both the BIOS and NT see the same amount. This is not being caused by a /maxmem switch in theboot.ini file (see microsoft kb article 108393).

Is there some other setting (registry?) that could be causing this limitiation? Is it possible that the memory modules can be seen by the BIOS but not NT? Any ideas?

Thanks!

5 replies

by curlergirl

Seems unlikely, but - see if your BIOS has a setting for "plug 'n play OS" and make sure it is set to "no". As you know, NT is NOT P&P, so if this setting is "yes" it might cause the OS not to be updated properly w/BIOS changes. Hope this helps!

by russlang

Thanks for the idea.

I checked the BIOS, no such switch for plug-n-play which is not suprising since it dates to 1992!

What I am wondering is this: Is it possible that the BIOS thinks the memory is OK but that NT doesnt? I would think that if it passes the BIOS memory test then the modules that are in there must be compatible with the system- is this correct?

by thechas

Check the BIOS for an OS/2 switch for memory over 64MB.

OS/2 had a problem with more than 64MB of RAM.
The fix, was to add a switch to the BIOS code to ignore memory over 64MB if OS/2 was installed.

Chas

by russlang

There's nothing in the BIOS setup screens about OS/2, and OS/2 is not installed on this PC. The BIOS is Phoenix version 1.03. During boot-up the BIOS sees the correct amount of installed memory- but at the NT startup blue screen and thereafter the system sees only 65MB. If I install 64MB of RAM NT sees 64MB but any more than that and it sees only 65MB.

There is a switch you can add to c:\boot.ini "MAXMEM=XXX" which will limit the amount of RAM NT will use. I have tried leaving this switch out and setting it to MAXMEM=192 with the same results. If I set it to MAXMEM=48 then NT shows that the system has 48MB.

So it seems like somewhere else there is a limit of 65MB being placed on how much memory NT will see and/or use.

I tried looking thru the registry and found a key: HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\SystemStartOptions MAXMEM=192
There are also keys ControlSet001 & ControlSet002 with the same setting.

Nothing shows up in the Event Viewer or the NT Diagnostics utilities.

I really appreciate the suggestions so far, are there any others? Any other place to raise this question?

Thanks!

This discussion is closed to new replies.