Discussion Locked

NT 4 to Win 2k migration

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Can anyone point me in the right direction or give me some guidelines on how to migrate my LAN from NT 4 to Win 2K Server on a new machine that had it pre-installed?

3 replies

by timwalsh

The keys to migrating are as follows:
1. Active Directory (AD) MUST be installed on a Win2K server for it to become a Domain Controller.
2. Win2K Domain Controllers cannot exist in a NT4 domain.
3. Win 2K and AD MUST be installed on a NT4 PDC to migrate your domain.
Therefore you have 2 options to start:
1. If your present PDC meets the hardware requirements for Win2K, load Win2K on that machine. When the setup program realizes it is being installed on a PDC, AD setup will be automatically invoked. AD also needs access to a DNS server to successfully install. Once Win2K (and AD) are installed, install AD on your new server (which will then make it a domain controller). (if you will be removing the old server from the network,transfer all server roles to the new server before taking the old one off-line.)
2. Install NT4 on your new server (as a BDC). Promote it to PDC (which demotes your old server to BDC). Remove your BDC from the domain (to act as a fall back in case your migration does not work successfully). Follow the steps as in 1 above.
Option 2, although entailing more work (installing NT4 and then reinstalling Win2K), gives you the added benefit of a fallback position (an available NT4 BDC that can be quickly promoted to PDC) if your Win2K install falls apart (it does happen sometimes).
Also realize that the above steps are not all-encompassing. There is much homework and design that must go into a successfull AD domain.
Hope this points youin the right direction and Good Luck!

This discussion is closed to new replies.