Discussion Locked

NT sending out DHCP requests_not enabled

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Problem: The Unix box syslog is filling up with requests for a name to associate with the IP address of an NT box. I quieted that with an entry in the bootptab file.

However A sonicwall appliance is also logging requests: Message: UDP packet dropped. Notes: DHCP.

So there is still unnecessary and unwanted traffic on my network coming from the NT4.0 Terminal Server sp6 box. DHCP is not enabled.

Where are these requests and traffic coming from??????

Thanks,
Steve

2 replies

by nikolaus

I found similar effects within my network, after i established a modem dial in facility using RAS on an NT server. I figured out the following:
RAS service was configured to assign all the IP settings to the client upon dial in.
On any dial in activity, it sent out DHCP requests.
I didn't had the time to figure out, what settings within RAS configuration and/or registry are needed to stop that or even to convert that nasty broadcasting into directed DHCP requests towards the one and only DHCP server in my network.

by scrow

Thank you, first I tried stopping the RAS, no change. The I stopped the Remote Access Autodial Manager and the entries stopped.

Question, can someone fill me in on what this autodial manager does and suggest some config settings?

This discussion is closed to new replies.