Discussion Locked

NT4 and HP 4C scanner

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Have an NT4 workstation running with a Hp4C scanner and HP 9200 external burner. Both devices hang off an Adaptec 2930 scsi card with the scanner terminated at the end.
BSOD displayed with IRQL_not_less_or_equal_than.......aic78xx.sys
stop error.Error is not critical as system can be rebooted by removing the scsi cable or a ram stick and then operated normally. Closing system and reinserting these devices allows system to reboot as normal.
Any help?

7 replies

by leo.valmores

It seems like an IRQ or I/O memory conflict or BIOS settings corruption.

When you boot, invoke the SCSI card utility like CTRL A. From here check if the two devices are recognized and what their respective settings are.

Also when the system isrebooted and goes normal (with the two devices attached), try to check with NT Diagnostics (Start > Programs > Admin Tools > WIN NT Diagnostics). This should also tells you what settings your SCSI card, Scanner and burner is set to. Finally, as a last check when did you last replace/check backup battery on motherboard?

by inspectorclave

You will get this error anytime a device conflicts with the system or another device. Check to make sure that each SCSI device has a unique ID number. You may want to reinstall the last SCSI device to make sure that the numbers are correct.

by rogerndgreen

Has this ever worked correctly? If not, you could well have duplicate SCSI IDs for the scanner & burner (every SCSI device on a single chain *must* have different IDs).
Check the settings (either via WinNT diagnostics, or by physically looking at the devices and checking the docs that came with them.

This discussion is closed to new replies.