Question Locked

ok this shouldnt be to hard of a question

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I want to make a usb eathernet cable my eathernet cord has a total of 11 wires bl-w,bl,grey-w,grey,red-w,red,orange-w,orange,yellow-w,yellow, ground
my usb cable red,white,green and black\
I know that the usb red is vbus,white is for data -, green is fo data + and black is ground
so witch ones do i conect

3 replies

by thechas

Just so I have this straight, are you trying to make a cable to connect to your USB and Ethernet port?

Or, do you want to connect an Ethernet signal to a USB port?

If you want to make a connection between an Ethernet cable and a USB port, it is much more than what wires go where. You need to have a translator chip between the Ethernet and USB signals. The communication protocols, packet structure and I believe signal levels are different between the 2 standards.

I know that Netgear sells a USB to Ethernet adapter that is reasonably priced.

You can also find translators that allow you to extend a USB line by up to 350 feet using Ethernet cable.

But, a direct connection between USB and Ethernet will not work.

Chas

This discussion is closed to new replies.