Discussion Locked

Paging File Problems

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

ok my PC shut down fine, and when I turned it on I got the following error message.

Your system has no paging file, or the paging file is too small.

It then gives me instructions on how to fix it, but even when I increase the size of the paging file and registery, apply and restart, it does the same thing. How do I fix this? I have tryed everything (except formatting).

7 replies

by michael34

Thank You for the information, I Not sure what the problem was. I tryed everything, so I ended up formatting and switching to FAT32.

by sfhsgrad00

Since you've tried everything, I would reinstall the operating system. This should put a clean copy of Windows and all components back on your system. Make sure all of your important documents are backed up, just in case something goes wrong with reinstall. Should have no problems though, but better to be safe than sorry. Good Luck.

by michael34

Thank You for the information, I Not sure what the problem was. I tryed everything, so I ended up formatting and switching to FAT32.

by jim phelps

Did you have two hard drives at one time, and now only one? Because if so, Windows 2000 probably put the paging file on drive 2. Now that there is only one drive, you get the error message.

Even if you have never had a second drive in the computer, if you have an extra hard drive laying around, put it in the computer, then put your paging file on the second hard drive. See if that will make the problem go away.

by michael34

Thank You for the information, I Not sure what the problem was. I tryed everything, so I ended up formatting and switching to FAT32.

This discussion is closed to new replies.