Discussion Locked

Port filtering

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,

I have an NT 4.0 server. I would like to use only those ports that I really need and to block access to all others.

One solution is to enable security to TCP/IP protocol (advanced settings) for my netcard and to specify a DENY ALL policy EXCEPT some ports (TCP and UDP ports).

I am using the following services:

HTTP, HTTPS, FTP, SMTP, POP3 , IMAP, DNS.

Which TCP/UDP ports should I left open?

If you can suggest a specific policy of any other ports that should be left openplease tell me in order to avoid problems. I know that tough security might cause various problems to the operation of the Server.

I do not want to block a TCP or UDP port that might cause problems to any of the above services.

Thank you in advance.

5 replies

by joseph moore

>HTTP, HTTPS, FTP, SMTP, POP3 , IMAP, DNS
80 445 21 25 110 143 53

Hopefully that will come out in a readable form.

Just make sure you NEED to open all of these ports to the Internet on your NT machine.

by magellanix

That is JUST extremely RISKY for a server, instead what you should do is have a computer as a firewall sitting between the server you setting up and the internet, I recommend OpenBSD it won't cost you a sent, and you could have the firewall on an old 486 or something close to it etc... You get the idea, checkout openbsd.org also you will a much less chance of getting Rooted (depends how you configure the firewall :-D)

Cheers :-D
Thanks

This discussion is closed to new replies.