Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Windows NT 4 SP6 workstation. I was installing my digital camera software when the power went out during the middle of installation. I rebooted and windows nt will not start. The error message reads "Windows NT could not start because the following file is missing or corrupt: \WINNT\SYSTEM32\CONFIG\SYSTEM". I do not have any emergency recovery disk so is there any way to restore my workstation without re-doing everything? I have another NT workstation nearby. If there is a file I can copy from that one, let me know. Thanks
3 replies
by dmiles
It would be difficult to determine that the other machine will have the same setup,unless they are identical machines you will most likely have to re-install the operating system
Doing a repair to installation will not work because it will require the ERD,it is worth trying to use the setup disk if available to do a repair install of the operating system
Go to the following site to down load NT boot disk that may help
1)www.bootdisk.com
by joegrosskopf
Poster rated this answer
by joegrosskopf
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
20 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
14 replies