Discussion Locked

Printing across the WAN

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is this possible? I have a network printer with an internal IP at a remote office behind a 3com firewall that is performing NAT. On my computer at home, I add a new printer with Local TCP/IP port selected and I put in the firewall's external IP address. On that firewall I have the raw printer port 9100 forwarded to the printer's internal IP. After I install the printer I try to print a test page but it always fail's and give's me a "Document failed to print due to GDI/Driver error in rendering." error. I'm pretty sure it's getting to the printer cause on the firewall I can trace the packets going to the printer. It is only sending SYN's though and then resets. Is it even possible to setup a printer this way over the WAN? Test printworks fine on the local LAN. I can't set it up as a network printer to a share because ports 137-139 are blocked at COX's routers. Thanks for the help.

4 replies

by cul8rm8e

Configure the firewall to perform call ID translation for the General Routing Encapsulation (GRE)
protocol.
Configure the firewall to permit General Routing Encapsulation (GRE) traffic.

by scott r

I figured it out. I didn't have a default gateway setup on the printer. Stupid me!

This discussion is closed to new replies.