Discussion Locked

Problems with ati drivers and direct 3d

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an ati 9700 pro, 1900+ XP Soyo Dragon + Baord. When i try to update my video drivers i download them (for 98se) and uninstall my old ones. But when i goto install the new ones as soon as i open the exe it gives me the blue screen.. Also when i run the direct x diagnostics it disables my direct 3d. I have reinstalled directx 9 ABOUT 3 times. The newest driver i can use for my 9700 pro card are the wme-radeon-4-13-01-9062-efg.

5 replies

by thechas

Start by checking with SOYO for a BIOS update.
Many times new graphics cards have not been tested with all existing hardware, and there may be a BIOS bug that can cause errors with some video cards.

Next, download and install the latest Chip-Setdrivers for the motherboard (VIA?).

Again, the AGP mini-port driver often needs to be updated to handle new video cards.

I would un-install all drivers,

Install the chip-set drivers,

Install DirectX,

Install the ATI driver.

You need to follow the above sequence to avoid problems with driver incompatibilities.

Chas

by quaint_data

yes Chas has answered this well, updating drivers I would not reccomend as 9 out of ten times you will have have major problems, do you have the original drivers on disk, uninstall your new one and put the old ones back, if you havent rebooted too many times you could try a system restore, at the dos prompt type system /restore make sure there is gap, cheak your dates if you can see a date that you know was before you installed the new drivers use that and your system will be restore to that.

This discussion is closed to new replies.