Discussion Locked

RAID 1 Mirroring in SBS 4.5

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 2 identical 6 Gig. drives on a SBS 4.5 system. The C drive has about
1.8 G. of used space. The NT4 resource guide recommends not mirroring a system drive larger than 1 Gig. The partition is NTFS and I don't think I can remove enough stuff to get it under 1 Gig. I tried mirroring as is and it won't give me the option when selecting the partition along with an equal sized non partitioned space.

12 replies

by dc1

You selected the 1.8 gig partition on the boot disk and then highlighted the second disk with enough disk space and choose to mirror them right? Software RAID isn't the great and if it is in the budget try to pick up a hardware RAID controller. Definately worth the investment.

by timber

Your system drive (drive one) is partitioned with a 6 GB Partition with 1.6G of data.. Your other drive an unpartitioned 6 GB drive (drive two). In Disk Manager Highlight drive one hold Controll and highlight drive two. Click Fault Talerance menu and establish a mirror. This process will take a little while to build the mirror.

Cont...

by timber

cont...
I have done this with two 9 GB drive with over 8GB of data and it worked fine. I however agree with DC if it's in your budget buy a RAID controller. The first time you have a serious problem you'll understand why!! It's too lengthy to discuss here!!

Good Luck

by Former member

Install drive, do not partition or do anything with it, goto disk manager and select C partition and ctrl key select unpartitioned drive, then select mirror. THere's nothing wrong with 1.8 GB mirrored partition..

by fred_e944

I don't remember ever hearing about a 1 Gig limit. I'm running SBS 4.5 with a 4.0 Gig system drive and 9 Gig data drive, both mirror sets, with no problems. Just make a mirror set with Disk Administrator in the usual way. It will have to be 4.0 Gig or smaller since SBS installs by formatting the drive to FAT then converting to NTFS at the end of installation, resulting in a 4 Gig limit. After creating the mirror be sure to run the Exchange Server Performance Optimizer and accept its recommendations for which drives to put the databases and logs on. Make sure you are familiar with the procedure for editing boot.ini for recovery of a fault-tolerent system.

by fred_e944

I don't remember ever hearing about a 1 Gig limit. I'm running SBS 4.5 with a 4.0 Gig system drive and 9 Gig data drive, both mirror sets, with no problems. Just make a mirror set with Disk Administrator in the usual way. It will have to be 4.0 Gig or smaller since SBS installs by formatting the drive to FAT then converting to NTFS at the end of installation, resulting in a 4 Gig limit. After creating the mirror be sure to run the Exchange Server Performance Optimizer and accept its recommendations for which drives to put the databases and logs on. Make sure you are familiar with the procedure for editing boot.ini for recovery of a fault-tolerent system.

This discussion is closed to new replies.