Discussion Locked

RAID 5 Partitioning

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm planning on installing a RAID-5 set with the drives. Does anyone know if the RAID set can support multiple partitions.

- D

9 replies

by mckaytech

A RAID array appears, to the operating system, just like a logical drive, so anything you can do with a logical drive, you can do with a RAID array and that would include creating up to four partitions (under NT 4.0).

paul

by wburdine

NT provides a "software" RAID solution, which is fine if you don't ever expect a drive to fail, but its a pain in the ass if want to pull a bad drive and replace it then reconfigure. I use a Hardware RAID solution. This allows me to configure the RAID via an individual program prior to Windows booting and Windows looks at it how you set it up. If you have 5 physical drives and you set up a RAID5 via Hardware, then windows and FDISK see it as only 1 large drive, from here you can partition it any way you want and not worry how the FDISK or NT does it, because the hardware does all the translation for you. And if a drive dies, no prob, pull it out replace it with a similar size, and the Hardware RAID will rebuild the missing data on the fly.

by mark_lt

Setup your redundant drives, then install NT (it may need the nt driver for your hardware controller)

Create your install drive in the NT setup.

When NT is all done, go to disk admin and do what you want with the remaining drive space.

This discussion is closed to new replies.