Discussion Locked

RAS setup problems

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am setting up RAS on my NT server so that users can dial in. When they try to dial in, it says that the server is not answering. I have the right phone number set up. I don't have DHCP or WINS set up on my server. Is that the problem? I can just use static IP addresses right? Any suggestions?

10 replies

by ianknapper

Two things spring to mind:

Have you given the users Dail-In permission in the NT user accounts?

Is the Routing and Remote Access Service started?

Other than that check the modem manufacturers web site for patches?

by jcorlett

I've seen this when RAS is configured to use DHCP but there is no DHCP server available. Here's a few things to check:
* Replace your modem cable with a known good one.
* If modem is internal make sure the IRQ settings aren't conflicting with any other device.
* Check RAS properties in network services for correct IP addressing. You can use hard-coded IP add. but they have to be valid on YOUR subnet.
* While your there (RAS Properties), also make sure your ports are configured to recieve calls.

by ratherbfishing

It sounds like the modem is not answering. This usually means a phone line or modem rather than NT problem. Test it by calling the number with a phone and seeing if the modem answers (you will get the hideous squealing sounds). If it does not answerbut just rings and rings than doublecheck your phone number, the modem settings and modem cable.

And yes you can use static IP addresses setting them up in the dialup networking configuration on the client. If you have a WINS server on your network you can enter its IP address also.

by caser85

These all sound like really good suggestions. I do have the permissions set for dial in access. I have the RAS service running. I'm not sure about the modem being compatible. I know it works for other programs because it works for WinFax.

How doI enable a port to receive calls? I will try calling the modem to see if it responds. Thanks for the good ideas! I will try these and write you back.

Casey

by vyun

I've had this problem before. Make sure the RAS services are running and are set to automatically start at Startup.

This discussion is closed to new replies.