Discussion Locked

Reads from all CDroms at once at times

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm running Windows 95 and have a program that runs of 5 cdroms (2 ide in the system, 3 ide in a scsi tower). Every now and then the system acts like it's trying to read all 5 cds at once (all the lights flash at the same time)and fails to read thecd rom and give you an error "unable to read cd-rom". If you wait till all lights stop flashing and retry, everything is back to normal. The system including cd tower have been replaced. Has anybody run into a problem like this?

5 replies

by oneonlysupermouse

I once had a burner that spun up so fast that it took power away from the main hd, so since i had a huge server tower i installed a second power supply and it fixed it just fine. That should help

by funinalaska

Ah, Win95 a progarm I am proficient with. OK, go to Safe Mode, Boot up, hit F8, option, SafeMode, then go to Contol panel, system, check the cd properties to see what IRQ was assigned to each one. If one IRQ is running all of the same slots they might be conflicting. Re-assigning them under the Resource Tab might to the trick. Reboot back to normal(real time) and go to the same place and check to see what that shows, Are they the same? If not you can adjust in real time. Then shut computer off for at least 1 min so it can save your work to hard drive. Reboot, try the CD program again, by the way the software installed for the CD program could be the culprit also. Perhaps a better software program like Roxie would help?
Hope this helps.

by quaint_data

as I am not real professed with 95 this is for consideration only, but how about removing the hardware physically, turn off the machine of course, and then add one at a time, switching off machine each time, hopefully windows will detect them and make each a slave with the correct resources.

by michaellass

The system can see all the drives and the system runs fine. It's just every now and then it seems to be looking for information on a cd from all drives at the same time and gives you an error "Can't read from CD-Rom" click ok and the system is back to normal and it reads the cd from the one drive

This discussion is closed to new replies.