Discussion Locked

RedHat Install equals MegaRAID confusion

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm installing RedHat 7.2 on a server that has MegaRAID SCSI RAID controllers. The redhat install is seeing the first RAID drive as the first bootable device instead of the real first bootable hard drive. Win2K locates the C:\drive and installs fine. What Win2K sees as the F:\drive Linux is seeing as the C:\drive. As a result, Linux will not boot because it is looking at the wrong device as the first bootable drive. Help!

5 replies

by merrill.burrows

Problem solved. I cleared the RAID configuration and disconnected the RAID array from the SCSI controllers. Then I installed Linux without any problems. I rebooted, reconnected the RAID array, and reconfigured the RAID. Linux recognized the RAIDand I'm in business. Thanks for taking the time to reply.

by servermonkey

Check your grub.conf/lilo.conf file to make sure it is pointing to the correct boot partition. Did you configure the machine with hardware raid using the controller or are you using software raid? Is this a dual boot system. If so, did you install Windoze after linux or vice versa?

by merrill.burrows

Problem solved. I cleared the RAID configuration and disconnected the RAID array from the SCSI controllers. Then I installed Linux without any problems. I rebooted, reconnected the RAID array, and reconfigured the RAID. Linux recognized the RAIDand I'm in business. Thanks for taking the time to reply.

This discussion is closed to new replies.