Discussion Locked

Reloading Images of PC's from NT Server

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have been experiencing number of Hard Disk failures lately and wish to copy the images of the Hard disks of all the PC's on my network onto the server and reload them when the hard disk fails. Creating a copy of this Disk using Ghost or its equivalent is relatively easy manually, is there any automatic way to do this? Also what is the easiest way to reload the image? I have tried to create network enabled boot disks but it is a bit problematic with different NIC's. Are there any White Papers, Books, Sites around that give advice on this area?

7 replies

by erikdr

Well it isn't *that* difficult.
Firstly Ghost 6.5 offers an improved boot partition utility, in which multiple NIC's are supported in parallel. Whether this also will extend to boot disks (with their 1.4 M diskspace limit) I'm not fully certain, but an upgrade is worth a try.
Secondly Ghost, again, offers commandline switches for almost all options. So the restore (reload) operation could simply be starting the boot disk, selecting 1 option at startup and having the full reload being done automatically.

As for websites, you could take a look at www.swynk.com for advice on SysPrep - an aid in the cloning process.

Hope this helps,

/ The Netherlands

by Former member

You'll have to create a seperate disk for each different NIC. I was once able to use one disk for several different types of NICs, but I cheated and used Novell DOS client drivers and used error codes. The Novell drivers would attaempt to load theirNIC driver and if it failed, moved onto the next one. Once it found the right NIC, it copied the system.nic and protocol.nic to .INI files and loaded that specific NIC driver. It was a little complicated, but it worked good!

by rmiller

I have done this, I used Drive Image Pro (much easier to configure the network drivers than Ghost) Drive Image uses TCP/IP. You do have to make a seperate set of boot discs for each NIC but it is an automated process you do on the PC. I have 99% Dells and use the same boot disks for all - 98 or NT doesn't matter. There are some scripting options but I didn't get into that. You should be able to get an evaluation version off the powerquest web site.

This discussion is closed to new replies.