Discussion Locked

Remote management problem

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a lab of PC's that all work fine exept one. I cannot remotley access theis one PC at all from the DC logged in as the Administrator. The machine is properly joined to the domain, and everyhing outgoing works fine. I tried plugging it into theport for the PC next to it, and I was able to manage it remotly, and access the drive. I then re-terminated both ends of the run and re-certified it, and it still did not work. I then ran a new cable, terminated it into a different port ont he patchpanel and used a ner Cat5e connector on the PC end, certified it, and it still doesn't work, even with a new run. I also tried new patch cords. Anyone have any idea what's going on?

3 replies

by ann777

Have you looked at the software settings on the computer? The user(s) may have turned off remote management on that particular computer.

by dave

No, that's not it. As I said above, if I moved the cable over to the next port, it worked, but doesn't work in it's own port, even though I ran a new cable with a new jack at the PC and have it punched in to a different port in the patch panel, andwith different patch cords.

by lmayeda

What happens if you plug in another PC to the port in question ...does it still work? Have you checked the if the port is half/full duplex?

This discussion is closed to new replies.