Discussion Locked

remote printing priblem in staroffice

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Dear all;
I have the server running with sco unixware 7.7.1 and client running with caldera openlinux 2.2.14. My dotmatrix printer is connected to remote unix system.I configured
remote printer from client (linuxsystem)with linux i getting remote print but from star office which is runnig on clinet side i am not getting remote print can any one help regarding above.

thanks.....
bsrao

6 replies

by bg4

Bsrao, I gather you can print form the linux client but just not in Star Office. Assuming that the client "lp" is setup in the printcap file to point to the remote printer then you need to make sure the printer that Star Office is looking for is thelocal printer "lp". I have this setup and it works well.

Check in the file /home/use/office52/share/xp3/Xpdefaults
This is well documented and should help you solve your problem.

Hope this helps.

by shanghai sam

Dear bg4;
u are not got my problem.i tried as per ur suggestion.
Thing is i have the printer connected to remote unixware 7.1.1 .my client is caldera openlinux 2.2.14 and star office 5.1.I can able to print remotely from my operating system (linux)but not from staroffice 5.1.if i give any print itis not giving any error message but not printing.

pl give the brief lesson on this

Thanq
bsrao

by bsrao_lalita

Dear bg4;
u are not got my problem.i tried as per ur suggestion.
Thing is i have the printer connected to remote unixware 7.1.1 .my client is caldera openlinux 2.2.14 and star office 5.1.I can able to print remotely from my operating system (linux)but not from staroffice 5.1.if i give any print itis not giving any error message but not printing.

pl give the brief lesson on this

Thanq
bsrao

by bg4

Bsrao, email me a copy of your printcap file and your Xpdefaults file from the caldera PC and the printcap file from the unixware PC to linux@rag.com.au. I will have a look and see if I can sort out your problem.

This discussion is closed to new replies.