Discussion Locked

REPLACED B 130 SCREEN BUT DOSE NOT HAVE BACK LIGHT

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I HAVE REPLACED THE SCREEN ON MY DELL B 130 BUT IT DOES NOT BACK LIGHT. ANY HELP?

1 reply

by robo_dev

Unplug/reseat the connector where the display connects to the system board. This is typically the larger cable, versus the signal cable which is skinnier.

Did you replace the whole display assembly as one part, or take it all the way apart?

If you took it all the way apart, make sure you did not damage the backlight bulb, like breaking the end off it, or knock off the wires connected to it. The backlight bulb is very fragile.

Did the old display backlight invertor fail? (In other words, why did you replace the display).

If the old display invertor failed, it's possible it destroyed a component on the motherboard of the laptop when it went.

You should post this as a Question, not a discussion.

Typing in all caps is SHOUTING online...

This discussion is closed to new replies.