Hi guys
I got a acer 4620z in i replaced the dc jack in it , every thing was fine for few hours , i returned it to customer , and got a call in the morning that it quit , so i got it back and looked over my solder points ,found one that i resolder ,
i put it back together and plugged it in with the battery in it , and it ran on ac till it booted then switched back to battery power , i took out the battery and tried to run it off ac but no power no leds , so i went back in and looked at all of the solder points and they all seem fine ,,
i did see where the voltage regulators that are close has a small melt on the plastic where i must of touched with the iron ,,
so I’m looking for little incite on what could cause this ,, with battery she runs fine
thanks