Discussion Locked

Restoring Active Directory

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I would like to know how to restore active directory. What I have seen on Ms's site is either vague or nearly impossible to dicipher. Any resources ,white papers, or advice would be greatly appreciated. Thank you.

3 replies

by alima

To restore active directory you have to run backups of your system state data through either the Backup in 2000 or Veritas some type of backup program. If their is a failure, I am not a hundred percent sure but I think you have to run a utility thorough Recovery Console. I am going to try to look that up and post again.

by alima

If you have a backup of the system state of that domain controller using ntbackup or veritas you can restore the system state. However, their is a utility that can be run from a command prompt called ntdsutil that will authorize the backup of that active directory. So try to look for NTDSUTIL. I hope this helps somewhat look for knowledge base article 241594 or Q241594 discusses some of the ntdsutil command on microsoft's website or try searchingin their how to section on the website. Hope it all works out.

by joseph moore

Well, your question is also vague, so I can't give you an exact fix.
Normally, if you lose your AD server and you need to restore it from a backup, you have to run the "Directory Services Restore Mode" bootup option.
Here is a nice Technet article about this:

http://support.microsoft.com/?kbid=240363

hope this helps

This discussion is closed to new replies.