I have an old P2 400mhz with 256mb of PC100 RAM sitting around (was a dell if you can remember those guys). I have great aspirations to make this into my webserver witha 40gig HD. I want to run RH9 but I am running into a problem. To test it out I installed RH9 in workstation mode. It looks great on boot but as soon as you enter the GUI it starts slowing down. At the point where control is turned over to me it takes 45seconds to a minute JUST TO LOAD A COMMAND LINE! I have asked this question before and found that others are running this same system with much luck. The question is “What process’s do I need to disable to run a stable Webserver from my home”
Hope thats not too complicated. But in case it is im offering 300 points =)
