Discussion Locked

Router: each port is separate network

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am looking for a router where each port can be designated as a separate network. I need to support no more than 8 separate networks, but each network must be independent of the others. All ports must share a single public IP.

Is there anything that can handle this need?

3 replies

by bvogel

From what I know of routing, unless you enable bridging on router ports, because of the nature of routing, each port is it's own seperate network. For instance, I have a Cisco 2610 router here with one ethernet and one WAN port. Each port has it'sown directly attached network (one has two networks), and the router does the transfer packets from one to the other based on the rules I specify in the Cisco IOS. Make sense?

Brandon

by ednichols

Thanks for the insight. I've only used smaller SOHO routers which do not provide that capability. If I understand you correctly, you are saying that I can put multiple cards in the cisco router. One is obviously the WAN port and each additional card creates a separate LAN.

Not only does it make sense, but it also makes sense. :-)

Thank you.

by f34

i have 2 segment (class B with 254 host)but it is a flat LAN with no Layer 3 switch/router capabilities...originally was configured to cater only 1 segment...then we decide to extend and Add another class B segment...what is the impact of the modification on the router...from performance wise???

This discussion is closed to new replies.