3 replies
by lordinfidel
If you are not sure about routing and have not done this before.
My advice would be to contact your ISP and see about hiring a engineer.
They won't be cheap. CCIE's generally get on avg $200/hr. So make sure that you know what you want to dobefore hand.
Unfortanetly there is just 2 much information that would need to be covered to get your 2 networks up and running.
Sorry for the bad news. But it sounds like it's time to call in an engineer.
by ebob
Your PTT can verify that you have connectivity between the CSU/DSUs at each site (or at least between the demark points if they did not also supply the datasets).
Having established that, and assuming that you're running TCP/IP, and that routing is appropriate between sites (as compared with bridging - yuk) you need:
- a subnet for each site
- a small subnet for the serial line
- a router at each site
Plug the router into the dataset at each site, and with a console in the console port of the router, power the routers up.
You should be able to enter a comand to display the interfaces ("sh int" in Cisco) at the command prompt, and somewhere in the results should be an indication that it has found the Serial port ("S0" or "Serial 0") and that it is "up".
Great.
Contact the vendor to see if they have a config wizard, or sample config files, then setup a config file, applying the appropriate subnet masks and addresses. Remember, the serial ports need to be on the same subnet as each other, but have different addresses, and the need to be on different subnets than the LANs at each site. Remember also that each LAN should have its own subnet, and the Ethernet ports on the routers should be addresses from the range for each subnet. And make sure to exclude these addresses from your DHCP scopes.
E.G.,
LAN "A":
Network: 192.168.80.0
Router Ethernet: 192.168.80.1
Available addresses: 192.168.80.2 thru 192.168.80.14
Broadcast: 192.168.80.15
- subnet mask: 255.255.255.240
LAN "A":
Network: 192.168.80.16
Router Ethernet: 192.168.80.17
Available addresses: 192.168.80.18 thru 192.168.80.30
Broadcast: 192.168.80.31
- subnet mask: 255.255.255.240
Serial Connection:
Network: 192.168.80.252
Serial at LAN "A": 192.168.80.253
Serial at LAN "B": 192.168.80.254
Broadcast: 192.168.80.255
Hope that helps.
by ebob
LAN "A" and LAN "B", not both "LAN `A`"
(of course...)
This discussion is closed to new replies.
Trending IT Employment posts
Sort by Trending