Discussion Locked

slow network with collisions in hub

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have domain with windows 2000 server and windows nt client machines. i have setup the network with one hub and one switch. and combined hub and a switch with a uplink in the hub to the switch normal port with a straight cable. server ip is 1.1.1.1 with subnet mask 255.0.0.0. the problem is this that the network is slow and hub shows the collision when pick some software for installation from the server or some other client machine. i can access sometimes other computer very slow and even sometimes it shows a error that the network not found. i am really upset and exaust . plz help me out to tell me the right and quick way.

i will be grateful to u.

regards

2 replies

by jschein

Please be a little more detail as far as your setup...

You said 1 hub and 1 switch... Elaborate...

How many ports used on the hub & switch, are they both 10/100's or 10 or 100?

How many pc's and how many servers?

Server connected to hub or switch?

by sgt_shultz

you may have a bad nic creating a broadcast storm or something...try locking everybody down to 10MB half duplex. then reset (power off and on) the switch and hub. if still problem, might be incorrectly wired patch cables (did you wire them?) or bad nic or maybe virus??
did this ever work right? what changed?
1) eliminate viruii, spyware, kazaa etc as possibility.
2) lock down media type on all nics
3) that ip address is giving me shivers. why did you pick it?
4) divide and conquer. take half machines off network. test. if still problem, take half of remaining off. if problem shows up, put half of disconnected computers back on etc etc. to isolate problem.
you don't mention what you have tried. when you are rested up, tell us more. it is always fixable do not despair. think hardware if you have elimated other obvious stuff...

This discussion is closed to new replies.